Need a part number

[brokedown]

Im Installing 52" rear blazer springs in the front of my 86 GM 4x4 and i need to know the part number for the spring eye bushing. The Inside diameter of the eye is 1.5", the springs are 2.5" wide and i need a half inch shoulder,  thanks for any help.

[EnergyGeek]

brokedown,

Normally we can only look this stuff up by application but I took a guess on this one.  You didn't list your bolt size for the I.D. but if it's a 9/16th bolt then you want to go with part# 3.2130R, they are about an inch too long so you'll have to cut an inch off of the barrel but everything else should be good.  Let me know what you come up with

Energy

[brokedown]

your right on the money, 9/16 is it, thanks a bunch, you saved me a alot of time.

[brokedown]

I just got off the phone with my local energy suspension dealer, he says the bushings Im after are out of stock with a 5-7 week ETA. Im kinda in a hurry to get these parts, What would you recommend? and also, is that part number for the set or Individually? Thanks again.

[brokedown]

brokedown,

Normally we can only look this stuff up by application but I took a guess on this one.  You didn't list your bolt size for the I.D. but if it's a 9/16th bolt then you want to go with part# 3.2130R, they are about an inch too long so you'll have to cut an inch off of the barrel but everything else should be good.  Let me know what you come up with

Energy

Ok so... i just finally got my Bushings, they had to be orderd from the US because none of the canadian warehouses had them in stock. They took almost 3 months to get here. They are NOT even close to the measurments you specified, theyre way too small. I realize that i didnt order them to my vehicle spec because it was a custom suspension refit, so in the end i guess im to blame. Either way im sitting here with a bunch of parts i cant use.

[EnergyGeek]

What part # are on the bushings.

Energy

[junkdealer2]

Those 52 inch springs must be the same as the 89 3/4 ton Suburban w/ big block. Some 1 tom pickups also use this same spring main leaf. 

[liufang898186]

A very good post and certainly these are points really useful.

[sp33dracerman]

brokedown,Normally we can only look energy suspension this stuff up by application but I took a guess on this one.  You didn't list your bolt size for the I.D. but if it's a 9/16th bolt then you want to go with part# 3.2130R, they are about an inch too long so you'll have to cut an inch off of the barrel but everything else should be good.  Let me know what you come up with

Energy

ya its the 3.2130R or 3.2130G if you want black

[liufang898186]

HaHA! I have already seen the great thing!!!

[topman26]

thumps up for your article, great post...